1.Strict ratio: Follow the ratio required by the instructions to ensure the best performance of the adhesive.
2.Full stirring: The AB components must be thoroughly stirred before use to avoid dead corners and ensure curing.
3.Clean surface: The surface of the adherend must be clean and water-free to ensure the bonding effect.
4.Grinding: In order to enhance the bonding strength, it is recommended to grind the adherend.
5.Joint design: Reasonable joint design determines the bonding strength.
6.Pre-mix and use: Adhesives should be prepared and used immediately, and fast-curing glue should not exceed 2 minutes.
7.Thin layer glue application: Appropriate heating can accelerate curing, and the glue should not be too thick, 0.5mm is preferred.
8.Fix under pressure: It is best to apply pressure or fix with a clamp when bonding.
9.Stand for 24 hours: Stand for 24 hours after bonding to obtain the best strength.
10.stir well: Single-component solvent-based or water-based adhesives need to be fully stirred before use.
11.Wait for bonding: After applying the solvent-based adhesive, wait until it is no longer sticky before bonding.

silicone adhesive products are as follows: Products-IOTA (siliconeadhesives.net)